How To Lay Engineered Wooden Flooring

Tired of the usual marble and concrete floor in your house? How about going for a more classic look with wooden flooring? Rather than using real solid wood for the layout, you can opt for engineered wooden flooring instead.

The benefits of this are that the entire installation process is quick and simple to pick up, plus the finished floor will be durable and free from warping due to its laminated texture. In the following sections, you will be taught how to lay engineered wooden flooring in a few simple steps.

Preparation procedures before laying engineered wooden flooring

You need to ensure that the sub floor is adequately cleaned up and close to level before you even proceed to learn how to lay engineered wooden flooring. Typically, there should only be a maximum difference of 2 millimeters within a distance of 2 meters, which can be estimated with a length of parquet. You will need to use a screed to flatten the surface if the sub floor fails to meet the requirement in terms of evenness.

As for the door frame, in order to allow a parquet board to fit under it, you will have to saw a groove at the bottom. In addition, if your sub floor is made of concrete, it is recommended that you lay a plastic sheet or sound insulating membrane. This is essential so that you will not experience any unnecessary echoes when something drops on the ground.

Final few steps on how to lay engineered wooden flooring

Once your sub floor is prepared, you can start bringing in the engineered wooden boards for the actual process. The boards should be aligned on the floor such that they are facing the daylight, and the female ends should be the ones facing the wall, though you are supposed to leave a gap of around 10 millimeters from the wall with the help of wooden spacers. When you are at the final board on the first row, attach it using a laying jimmy, making sure that the same amount of gap is maintained from the other wall as well.

Once you are done with the first row, apply some glue to the end joints as well as along the longer edge. The boards should be hammered tightly together and the joint must be completed with professional compression straps. Using a tapping block, the boards on the next row should be tapped together appropriately. If there is any pipe obstructing the laying procedure, you can drill some holes on the board and cut any piece off first. The moment the board is in position, you can use glue to stick the piece back to the original spot and hide it with pipe ferrules.

The last row should be installed using a piece of parquet to guide you, and the entire board should be left idle for a couple of hours so that the glue will dry. The scotia will be fixed after removing the spacers, but you should take care not to set them overly tight against the fitted floor. After one night, everything should be in place and you have successfully mastered the skill of how to lay engineered wooden flooring!